Ammann APH 110-95 - Table of Contents

1. Si cher heits be stim mun gen ...............3
2. Tech ni sche Da ten ....................5
3. Be die nung
3.1 Be schrei bung .......................7
3.2 Be dien ele men te .....................7
3.3 Vor der In be trieb nah me .................8
3.4 Deich sel ein stel len/ar re tie ren ...............8
3.5 Be die nung Mo tor .....................9
3.6 Be trieb..........................11
3.7 Elek tro ni sche Tot mann schal tung .............12
4. ACEe con
4.1 All ge mei nes .......................14
4.2 Be trieb..........................15
5. Trans port
5.1 Ver la den und trans por tie ren...............16
6. War tung
6.1 All ge mei ne Hin wei se ..................17
6.2 War tungs ta bel le .....................17
6.3 Schmier plan .......................18
6.4 Fir men al ter na ti ve Schmiers toff ta bel le ..........18
6. War tung Mo tor
6.5 Über sicht ........................19
6.6 Kraft stoff an la ge .....................20
6.7 Mo tor öl stand prü fen ...................24
6.8 Luft fil ter .........................25
6.9 Kühl sys tem .......................26
7. War tung Ma schi ne
7.1 War tung Ma schi ne ...................27
7.2 Hyd rau lik ........................30
8. Bat te rie .........................33
9. Hil fe bei Stö run gen ..................35
10. La ge rung ........................42
1. Sa fe ty re gu la tions ...................45
2. Tech ni cal Data .....................47
3. Ope ra ti on
3.1 Des crip ti on .......................49
3.2 Ope ra ting con trols on the tow-bar ............49
3.3 Be fo re ope ra ti on.....................50
3.4 Ad ju sting / lo cking the tow-bar .............50
3.5 En gi ne ope ra ti on ....................51
3.6 Ope ra ti on ........................53
3.7 Elec tro nic dead man’s con trol (op ti on) .........54
4. ACEe con sys tem
4.1 Ge ne ral .........................56
4.2 Ope ra ti on ........................57
5. Trans port
5.1 Loa ding and trans por ta ti on ...............58
6. Main ten an ce
6.1 Ge ne ral no tes ......................59
6.2 Main ten an ce sche du le .................59
6.3 Lu bri ca ti on sche du le ..................60
6.4 Al ter na ti ve lu bri ca ti on sche du le .............60
6. En gi ne main ten an ce
6.5 Ge ne ral view ......................61
6.6 Fuel sys tem .......................62
6.7 Check en gi ne oil le vel ..................66
6.8 Air fil ter .........................67
6.9 Coo ling sys tem .....................68
7. Ma chi ne main ten an ce
7.1 Ma chi ne main ten an ce ..................69
7.2 Hyd rau lic ........................72
8. Bat te ry .........................75
9. Trou bles hoo ting ....................77
10. Sto ra ge .........................80
In halt Tab le of con tents
1