Ammann ARX 26-2 - Page 49

45ARX 23-2 T4i, ARX 26-2 T4i
OPERATING MANUAL
Brake test button (A)
Used to check the correct brake function.
Calibration button (B)
Used to calibrate functions:
• start ramp HARD / SOFT
• activation of the left travel lever
• infra thermometer setting °C / °F
AMN138
Beacon and rear light change-over switch
(1)
• To the gear 1: The beacon is ON.
It is possible that the machine is equipped with abeacon but
the corresponding change-over switch is missing. In such
acase, the beacon will start in continuous operation as soon as
the ignition key is set to the position II.
AMN45
Dierential lock button (2)
It is used for turning on the dierential lock.
The dierential lock prevents the drum from slipping when
crossing adicult terrain.
Turn the dierential lock o after the dicult ground
has been overcome!
Engine speed control (3)
The control setting allows you to better adjust the speed and
the vibration power to the given soil conditions.
Idle speed: Set the control to the rst position.
Small working speed: Set the control to the position I (85%).
Big working speed: Set the control to the position II (100%).
Small working speed:
Frequency I
85% vibration capacity
85% travel speed (depending on the transport and working
speed change-over switch)
85% engine speed
Big working speed:
Frequency II
100% vibration capacity
100% travel speed (depending on the transport and working
speed change-over switch)
100% engine speed
0
1
2
AMN010D
Travel mode switch (4)
Loading mode (0)
• Limited travel speed.
• Activated dierential lock.
• Blocked working functions of the machine (vibration).
Working mode (1)
• Machine working speed (7 km/h).
• Option to activate the dierential lock for the time necessary.
• Option to activate the working functions of the machine
(vibration).
Transport mode (2)
• Machine transport speed (10 km/h).
• Deactivated dierential lock.
• Blocked working functions of the machine (vibration).
AMN83
Sprinkling potentiometer (5)
OFF in the position “0”. Turn the sprinkling potentiometer from
the position “1” to the position “MIN” to smoothly control the
sprinkling intensity of the drums.
AMN142
STOP
STOP
STOP
Emergency brake button (6)
Pressing the button activates the emergency brake of the ma-
chine. The machine stops, the engine shuts down. After activat-
ing the emergency brake button the indicator lamps for battery
charging (22), engine lubrication (23), parking brake (29) and
emergency stop (26) are shown on the display.