AMOT B - Introduction and Safety Information; Manual Scope and Coverage; Safety Precautions and Hazard Definitions; Product Support and Service Information

3
Introduction
Doc No: OMMB00010 Revision: 7 – Mar 2014
Section 2 Introduction
2.1 Scope
This manual details the installation, operation and maintenance of the
AMOT Model B Valve range.
2.2 Safety
Certain operations within this manual are potentially hazardous and
could cause injury to personnel or damage to equipment if the
instructions are not carried exactly as described. Where a significant,
potential hazard exists, the following text appears immediately before
steps in the procedure that present a particular hazard:
WARNING
A Warning identifies a hazard that could cause injury to personnel.
The text of the warning describes the hazard and details the
precautions that must be applied before the next step of the
procedure is carried out.
CAUTION
A Caution identifies a hazard that could cause damage to equipment.
The text of the caution describes the hazard and details the
precautions that must be applied before the next step of the
procedure is carried out.
Note
A Note contains supplementary information that may be useful to the
Operator before the next step of the procedure is carried out.
2.3 Product support
All necessary settings and, where appropriate, alterations inside the
equipment are described in this Operating Manual. If any difficulties
arise during start-up, you are asked not to carry out any unauthorized
actions on the unit. You could endanger your rights under the
equipment warranty.
For spares and service support, call the telephone number listed on the
back cover of this Manual.