What to do if FACP System Fault LED is illuminated on Ampac FireFinder II Fire Alarms?
If the FACP System Fault LED is illuminated, ensure the correct panel configuration. Also, check all connections for loose wiring.
What to do if FACP Earth Fault LED is illuminated on Ampac FireFinder II Fire Alarms?
If the FACP Earth Fault LED is illuminated, check all input and output cabling and wiring assemblies for shorts to ground.
What to do if FACP Warning System Fault LED is illuminated on Ampac FireFinder II?
If the FACP Warning System Fault LED is illuminated, check that the correct E.O.L. is fitted and verify that the wiring is connected correctly.
What to do if the RS485 Communication Bus is not working on my Ampac Control Panel?
If the RS485 Communication Bus is not working on your Ampac Control Panel, refer to the FACP LCD for potential break locations in the communication line. Verify that the SmartTerminal Diagnostic Config LED is flashing; if not, the FACP isn't communicating with the SmartTerminal. Inspect the RS485 cabling and, if flashing, check the SmartTerminal’s address.
What to do if the FACP Earth Fault LED is illuminated on my Ampac Control Panel?
If the FACP Earth Fault LED is illuminated on your Ampac Control Panel, check all input and output cabling and wiring assemblies for any shorts to ground.
What to do if the FACP Warning System Fault LED is illuminated on my Ampac Control Panel?
If the FACP Warning System Fault LED is illuminated on your Ampac Control Panel, verify that the correct End-of-Line resistor is fitted and that the wiring is connected correctly.
How to fix RS485 Communication Bus not working on Ampac FireFinder II?
Refer to the FACP LCD to identify any breaks in the communication line. Check if the SmartTerminal Diagnostic Config LED is flashing; if not, the FACP isn't communicating with the SmartTerminal. Check the RS485 cabling, and if the LED is flashing, check the SmartTerminal’s address.
General| Type | Fire Alarm Control Panel |
|---|---|
| Manufacturer | Ampac |
| Series | FireFinder II |
| Communication | RS-485, Ethernet (optional) |
| Zones | 2 to 8 zones |
| SLC Loops | 1 or 2 loops |
| NAC Outputs | Varies by model (typically 2 or 4) |
| Input Voltage | 120VAC or 240VAC, 50/60Hz |
| Battery Backup | 24VDC battery backup |
| Number of Zones | 2 to 8 |
| Communication Protocol | Proprietary |
| Compatibility | Compatible with Ampac devices and select third-party devices |
| Certifications | UL, FM, CSFM |
To Next Page
