Integrated Base Sounder
A sounder with two volume ranges 55–75dB(A) and 75–91dB(A)
which incorporates a detector base. It is supplied with ‘alert’ and
‘evacuate’ tones. The low tone range is useful in areas such as
hospitals where a fire alert is initially intended to warn staff only. The
sounder is set to high range for general use. Synchronisation of
tones ensures the integrity of the signal tones from different
sounders do not merge into one signal that could be mistaken for a
different tone.
XP95 Integrated Base Sounder
45681-278APO 201-0110 45681-304AMP
XP95 Integrated Base Sounder with Isolator
45681-292 201-0114 45681-292
45681-293 201-0119 45681-293
Open Area Loop Powered Sounders
The Intelligent Open Area Sounder is a loop powered, wall mounted
device offering a choice of three tones, Australian (AS1670-4), New
Zealand (NZS4512) and Europe (EN54-3) and incorporates
synchronisation of continuous and pulsed tones. This ensures the
integrity of the alert signals – tones from different sounders do not
merge into one signal that could be mistaken for an Evacuate
signal.
A nominal sound output of 96dB is achieved at a current
consumption of 5mA while the acoustic self test feature enables the
sounder to listen to itself when switched on and if no sound is
detected, a fault signal will be transmitted to the control panel. A
yellow Fault LED will also be illuminated when a detection loop short circuit is detected.
XP95 Open Area Red Sounder
55000-001AMP 205-0100 55000-003AMP
XP95 Open Area White Sounder
55000-002AMP 205-0101 55000-004AMP
Loop-powered Beacon
The beacon has been developed to alert those with hearing
difficulties and to be used in areas with a high background noise
level. The beacon is fitted to any XP95 or Discovery base.
XP95 Loop Powered Beacon Red
XP95 Loop Powered Beacon Clear (Red Flash)
XP95 Loop Powered Beacon Amber
To Next Page
Loading...
