Ampcontrol CSM Pty Ltd - ABN 35 000 770 141
ECDB006 MEC-1 User Manual
MEC-1 USER MANUAL R0 13/03/2020 13:16 Page 5 of 18
1 SAFETY AND OTHER WARNINGS
For safety reasons, the MEC-1 must be installed, operated and serviced only by competent personnel. Read and understand
this instruction manual completely before installing, operating or servicing this equipment. Failure to install or operate this
instrument in accordance with the instructions contained in this manual may create hazardous operating conditions.
1.1 Safe Use of Equipment
The equipment supplied has been manufactured according to the state of the art, and designed to ensure a safe operation. The
equipment may only be used within the design parameters.
The instructions within this manual must be observed as an aid towards achieving maximum safety during operation.
The owner/user is responsible for observing the following instructions:
1.1.1 Changes to Equipment
Changes in the design and modifications to the equipment are not permitted. Unauthorised changes made to the hardware or
operating firmware will void the manufacturer's warranty, and may compromise the integrity of the system into which it is
installed and other connected equipment.
1.1.2 Equipment Knowledge
Experience with, or understanding of, this equipment is essential for the safe installation and removal of the equipment.
Therefore, in case of a question on how to safely proceed, contact Ampcontrol immediately.
1.1.3 Manual Handling
Precautions have been taken to ensure all equipment is safe to handle and free from sharp edges. However care should always
be taken when handling enclosures and gloves should be worn.
1.1.4 Installation
Correct operation and safety depend on the MEC-1 and associated equipment being installed correctly. Mechanical and or
electrical installation and maintenance of plant and equipment must only be carried out by appropriately qualified personnel and
must be tested thoroughly prior to operation.
1.1.5 Operation
As safety depends on the MEC-1 functioning correctly it is highly recommended that all safety functions of the MEC-1 be
periodically tested to ensure correct operation.
To Next Page
Loading...
