AmpliVox PC850 - Available Test Modes; Manual Test Mode

15
D-0116493-B (OM015) – PC850 Operating Manual
Use the left mouse button to click on the Launch Test icon in the Audibase toolbar.
Alternatively use the “Test > Launch Test” drop-down menu selection at the top of the Audibase window.
A new window will open for the PC850 software. If the patient has more than one set of audiometric results
stored in Audibase the most recent audiogram is transferred and displayed in the PC850 window.
The test type last used is remembered; if this was a manual test the procedures may be followed; if this was
an automatic test the following dialogue box will be displayed:
4.5. AVAILABLE TEST MODES
4.5.1. MANUAL TEST
While not strictly an “automatic” test, this allows the operator to use the PC850 software to transfer to
Audibase the results of a previous manual test. These could be either the “retained thresholds” (see Section
5.3) or the thresholds stored in one of the internal memory locations of the audiometer (see Section 5.4). The
audiometric data is transferred to Audibase in the same way as that for an automatic test.