30
D-0116493-B (OM015) – PC850 Operating Manual
If possible, use the use the “Edit > Cancel Insert/Edit” option in Audibase to discard any data, and then close
Audibase.
Depending on the task in process when disconnection occurred, the audiometer may lock up and not respond
to the controls. If possible, attempt to switch off the audiometer. Then remove the power from the audiometer
for several seconds. The PC850 may then be reconnected and Audibase started as usual.
7.9. ACCIDENTAL CLOSURE OF PC850 PROGRAM
If the PC850 program is closed while an automatic test is running the test will end and the “No results” message
will be displayed in Audibase. It will be necessary to switch the audiometer off and on. Clear any test results
and re-start the test.
To Next Page
Loading...
