17
D-0116493-B (OM015) – PC850 Operating Manual
To run the same automatic test using the same options (as last used) simply click the “Start test” button and
the test will commence (refer to Section 4.5).
If a manual test is required, or if the test options are to be modified, click the “Modify” button which will close
the dialogue box. Refer to Sections 4.4 to 4.7 and Section 5 as appropriate for additional guidance.
4.7. RUNNING A PREVIOUS TEST TYPE
To run the same type of test with the same options as previously used simply click “Yes” and the test will
commence as previously run (refer to Sections 4.3.5 to 4.3.9). The “Run selected test” icon will change the
following icon:
Assuming that an automatic test is in use, the serial number of the connected audiometer is shown at the
bottom right of the PC850 window and the status message “Running test” is displayed at the bottom left.
Additionally, the message “Linked” is shown on the display of the audiometer.
To view the traces of the presented tones select the “Show test detail” icon .
Alternatively use the “View > Detail” drop-down menu option.
To view the audiogram thresholds select the “Show Audiogram” icon .
Alternatively use the “View > Audiogram” drop-down menu option.
If thresholds are established at all of the selected test frequencies, the automatic test will finish with the
following dialogue box displayed:
Click “CONTINUE” to keep the PC850 program window open; this allows the user to perform further testing if
required - for example to repeat a threshold at a particular frequency.
Click “ACCEPT” to exit the PC850 program and transfer the complete test thresholds to Audibase.
Please note: When transferring thresholds to Audibase, remember to “save” the data in Audibase to
store it in the database (refer to the Audibase operating manual). If the data is not to be stored then the “Edit
> Cancel Insert/Edit” menu option in Audibase is used to discard it, or click the cancel insert/edit button on the
Audibase toolbar .
To Next Page
Loading...
