Amprobe AM-500 Replacement Instructions

English
AM‐500/AM‐510FuseReplacementInstructions(non‐EURversionsonly)
1. Pleaserefertohttps://www.amprobe.com/amprobe‐am‐500‐am‐510‐safety‐notice/forrelated
ImportantVoluntaryRecallInformationRegardingAmprobeAM‐500/AM‐510.
2. Replacethehighlightedfuse(suppliedwiththefusereplacementkit):
a. Disconnectthetestprobesfrommeasuringterminals.
b. TurntheMetertotheOFFpositionandremovetheholster(AM500only).
c. Removethescrewfromthe
batterydoorandremovethebatterydoor
d. Removethetwoscrewsfromtheenclosureandopentheenclosure.
e. Removethefuseidentifiedas“F2”belowandreplacewiththenewprovidedfuse
(10AH660Vfast‐fuse,6.3x32mm)
 
f. Reassemblyisthereverseofdisassembly.
g. Performcontinuity
testforAterminal–withproductinfunctionandtestlead
installedin/Vterminal,insertprobetipintoAterminal.
Productshouldreadlowresistance(<1).



Amprobe AM-500 Specifications

General

Max Voltage Measurement (AC)	600 V
Max Voltage Measurement (DC)	600 V
Max Current Measurement	10 A
Diode Test	Yes
Continuity	Yes
Battery Type	9 V
Safety Rating	CAT III 600 V
Type	Digital
Current Range (AC)	10 A
Current Range (DC)	10A