Amprobe IR-710 - Safety Precautions and Warnings; Laser Radiation Safety Warning; General Thermometer Operating Warnings; Protection Against Instrument Damage

3
Safety Information
The instrument complies with:
EN 61010-1 General Safety
EN 60825-1 Laser Safety
EN 61326-1 Electromagnetic Emissions and Susceptibility
Warning: Read Before Using
• Do not stare into laser beam.
• Do not point laser directly at eye or indirectly off reective surfaces.
• For use by competent persons only.
• Replace the batteries as soon as the low-battery indicator appears.
• Verify the tester’s operation by measuring on a known temperature source.
• Do not use the thermometer if it operates abnormally.
• Do not operate the thermometer around explosive gas, vapor, or dust.
• To avoid a burn hazard or re, know that reective objects may be much
hotter than the indicated temperature reading.
• Do not leave the thermometer on or near objects of high temperature.
• If the thermometer is used in a manner not specied by this manual, the
protection provided by the thermometer may be impaired or may result in
hazardous laser radiation exposure.
Cautions
To avoid damaging the thermometer under measurement, protect them from
the following:
• Do not stare into laser beam.
• EMF (electro-magnetic elds) from arc welders, induction heaters
• Static electricity
• Thermal shock (caused by large or abrupt ambient temperature changes —
allow 30 minutes for instrument to stabilize before use)
• Do not leave the thermometer on or near objects of high temperature