Need help?Do you have a question about the Amprobe VPC-10A and is the answer not in the manual?
Return defective tools to distributor for exchange during warranty period.
Send non-warranty repairs to Amprobe Service Center in US and Canada.
European non-warranty units replaced by distributor for nominal charge.
Tester automatically turns on/off based on circuit connection and selects mode.
Connect test leads to measure voltage; LEDs indicate levels based on rated voltage.
Procedure for measuring positive and negative DC voltages using the tester probes.
Wipe the case with a mild detergent solution and soft cloth; dry completely.
Replace batteries when continuity LED fails; disconnect power first.
Return defective tools to distributor for exchange during warranty period.
Send non-warranty repairs to Amprobe Service Center in US and Canada.
European non-warranty units replaced by distributor for nominal charge.
Tester automatically turns on/off based on circuit connection and selects mode.
Connect test leads to measure voltage; LEDs indicate levels based on rated voltage.
Procedure for measuring positive and negative DC voltages using the tester probes.
Wipe the case with a mild detergent solution and soft cloth; dry completely.
Replace batteries when continuity LED fails; disconnect power first.
General| Type | Voltage and Continuity Tester |
|---|---|
| Continuity Test | Yes |
| Pollution Degree | 2 |
| IP Rating | IP40 |
| Current Range | Not applicable |
| Battery Type | 2 x AAA |
| Detection Range | 50 to 1000 VAC |
| Operating Temperature | 0°C to 40°C |
| Frequency Range | 50 Hz to 500 Hz |
| Safety Compliance | CAT III 1000V, CAT IV 600V |
| Safety Rating | CAT III 1000V, CAT IV 600V |
To Next Page
