Amtrol T-5 - User Manual

READ CAREFULLY THE PRODUCT INSTALLATION,
OPERATING AND MAINTENANCE MANUAL.
FAILURE TO FOLLOW THE INSTRUCTIONS AND WARNINGS IN THE
MANUAL MAY RESULT IN SERIOUS OR FATAL INJURY AND/OR
PROPERTY DAMAGE, AND WILL VOID THE PRODUCT WARRANTY.
THIS PRODUCT MUST BE INSTALLED BY A QUALIFIED
PROFESSIONAL. FOLLOW ALL APPLICABLE LOCAL AND STATE
CODES AND REGULATIONS, IN THE ABSENCE OF SUCH CODES,
FOLLOW THE CURRENT EDITIONS OF THE NATIONAL PLUMBING
CODE AND
NATIONAL ELECTRIC CODE, AS APPLICABLE.
USE ONLY WITH POTABLE WATER SYSTEMS.
Do not operate in a setting with freezing
temperatures or where the temperature can exceed 200°F and do not
exceed the maximum working pressure specified for this Product.w
This Product, like most Products under pressure,
may over time corrode, weaken and burst or
explode, causing serious or fatal injury, leaking or flooding and/or
property damage. To minimize risk, a licensed professional must install
and periodically inspect and service the Product. A drip pan connected to
an adequate drain must be installed if leaking or flooding could cause
property damage. Do not locate in an area where leaking could cause
property damage to the area adjacent to the appliance or to lower floors
of the structure.
CALIFORNIA PROPOSITION 65 WARNING! This product contains a
chemical known by the State of California to cause cancer and to cause
birth defects or other reproductive harm. (California Installer/Contractor
- California law requires that this notice be given to consumer/end user
of this product.) For more information: www.amtrol.com/prop65.html
RUPTURE OR EXPLOSION HAZARD. Do not
expose Product to freezing temperatures or
temperatures in excess of 200°F. Do not adjust the pre-charge or
re-pressure this Product except during installation or regular inspection.
Replace the Product and do not adjust the precharge if corroded,
damaged or with diminished integrity. Adjustments to pre-charge must be
done at ambient temperature only. Failure to properly size the Product or
follow these instructions may result in excessive strain on the system and
may lead to Product failure, serious or fatal personal injury, leakage and/
or property damage.
A relief valve must be installed to prevent pressure
in excess of local code requirement or maximum
working pressure designated in the Product Manual, whichever is less.
At least once every 3 years or if discharge is present, a licensed
contractor should inspect the temperature and pressure relief valve and
replace if corrosion is evident or the valve does not function. FAILURE
TO INSPECT THIS VALVE AS DIRECTED COULD RESULT IN
UNSAFE TEMPERATURE OR PRESSURE BUILD-UP WHICH CAN
RESULT IN PRODUCT FAILURE, SERIOUS INJURY OR DEATH AND/
OR SEVERE PROPERTY DAMAGE AND VOID THE PRODUCT
WARRANTY.
Chlorine & Aggressive Water: The water quality
can significantly influence the life of this Product.
You should test for corrosive elements, acidity, total solids and other
relevant contaminants, including chlorine and treat your water appropriately
to insure satisfactory performance and prevent premature failure.
THERMAL EXPANSION TANKS
FOR POTABLE WATER
INSTALLATION & OPERATION INSTRUCTIONS
NOTE: Inspect for shipping damage. Notify freight carrier or store where purchased immediately if damage is present. To avoid risk of personal injury
and property damage, if the product appears to be malfunctioning or shows signs of corrosion, call a qualified professional immediately. Current copies
of the product manual can be viewed at www.amtrol.com. Use proper safety equipment when installing.
THIS IS THE SAFETY ALERT SYMBOL. IT IS USED TO ALERT YOU TO POTENTIAL PERSONAL INJURY AND OTHER
HAZARDS. OBEY ALL SAFETY MESSAGES THAT FOLLOW THIS SYMBOL TO REDUCE THE RISK OF PERSONAL
INJURY AS WELL AS PROPERTY DAMAGE.
Models ST-5 through ST-210V
Models T-5 through T-12

Summary

General Safety and Installation Warnings

Safety Alert Symbol and Manual Adherence

Alerts to hazards and stresses following manual instructions for safe operation and warranty validity.

Product Usage and Hazard Precautions

Covers potable water systems, rupture hazards, and water quality impact on product life.

Product Integrity and Relief Valve Safety

Addresses product failure risks over time and mandatory relief valve inspection.

California Proposition 65 Warning

Discloses chemicals known to cause cancer and birth defects as per California law.

Pre-Installation and Sizing Guidance

Pre-Installation Steps

Ensures proper sizing, air precharge adjustment to match supply pressure, and cap replacement.

Tank Sizing Chart

Provides charts for selecting expansion tank volume based on water heater temperature and supply pressure.

Installation and Operation Procedures

Expansion Tank Installation

Details on installing the tank on the cold water supply line and ensuring vertical mounting.

System Purging and Thermal Expansion

Guides on removing air from the system and managing initial thermal expansion.

Maintenance and Warranty Information

System Maintenance Recommendations

Advises yearly professional checks, including precharge verification for the expansion tank.

Product Warranty Details

Outlines limited warranty periods for different model series (ST and T).

Amtrol T-5 Specifications

General

Tank Volume	2 gallons
Capacity	2 gallons
Connection Size	3/4" NPT
Maximum Working Pressure	150 psi
Maximum Working Temperature	200°F
Maximum Temperature	200°F
Diameter	8.5 inches
Weight	5 lbs
Material	Steel