Amulet Hotkey DXT-H4 - Specify the Connection Broker; Using the Connection Broker

Network management
Page 28
6.2.2 Specify the connecon broker
You can use any of the available management tools (see secon
4.5 PCoIP management tools) to specify the connecon broker:
• you must provide the IP address or DNS name of the
connecon broker;
• you must also specify the Connecon Management
Interface connecon type for the PCoIP session.
6.2.3 Using the connecon broker
Instrucons for using a connecon broker to connect your zero
clients to hosts are available in the 
 (available to download from
).
Note: For further informaon about using connecon brokers,
contact Amulet Hotkey Technical Support. See also the
Knowledge Base Arcle 
 on the Teradici website.