6. Plug the Power Adapter into wall
outlet (Fig. 27A).
7. Wait for monitor to signal with a
beep. This may take 30 seconds.
8. Turn on cold water faucet and pull out the Diverter pin to run water through
the Water Purifi er. Make sure the display has a blue cup
(p. 11). If not, refer to Troubleshooting, Auditory Warnings (p.13).
4. Store the removal tool for future
use (Fig. 25A).
5. Place the Top Shroud onto Base
Housing (Fig. 26A).
6
Fig. 26A
Fig. 27A
Fig. 25A
To Next Page
Loading...
