AMX COLOR TOUCH PANELS WITH AUDIO (G3 FIRMWARE)

Programming
64
4" Color Touch Panels with Audio
Shorthand Variable Text Commands (Cont.)
@JUS
Sets the text
alignment on a
button.
Syntax:
"’@JUS’,<variable text address>,<text alignment>"
Variables:
variable text address = 1 - 255
text alignment = 1 - 9 as shown in the following alignment chart:
Example:
SEND_COMMAND TP,"’@JUS’,9,5"
Centers the text on button 9.
@SHO
Sets a specific
button to on or off.
Syntax:
"’@SHO’,<variable text address>,<button on/off>"
Variables:
variable text address = 1 - 255
button on/off=
0 : button Off
1 : button On
Example:
SEND_COMMAND TP,"’@SHO’,128,0"
Sets button 128 off.
@TXT
Adds text to a but-
ton.
Use the | character to display text on multiple lines.
Syntax:
"’@TXT’,<variable text address>,’<text>’"
Variables:
variable text address = 1 - 255
text = Enter button text to appear on the button.
Example:
SEND_COMMAND TP,"’@TXT’,2,’VCR|PLAY’"
Sets the VCR and PLAY text on variable button 2. The | character places VCR on a text
line above PLAY on the button.
@UNI
Adds Unicode text
to a button.
Characters for Middle Eastern languages, such as Arabic, are not supported within the
Unicode fonts because they are bi-directional. Buttons with Unicode fonts can only be cre-
ated and edited using TPDesign3 Touch Panel Design Program.
Syntax:
"’@UNI’,<variable text address>,’<text>’"
Variables:
variable text address = 1 - 255
text = Enter button text to appear on button.
Example:
SEND_COMMAND TP,"’@UNI’,2,’Foreign Text’"
Sets the Foreign Text on variable button 2.
1
4
7
8
9
6
3
2
5