ANCEL AD410 - Read Codes

2) Press ENTER to the Diagnostic Menu, screen will display as follow :
1-ttffil&ii
Erase Codes
VM Readiness
Data Stream
Freeze Frame
02 Sensor Test
4.2.1 Read Codes
'
1) Select Read Codes and press ENTER in Diagnostic Menu. If there are
some codes, the screen will display the codes as shown below:
13'11&,ii•Jii!H•b
Pending DTCs (S07)
Permanent DTCs (S0A)
2) Accordmg to the above figure
to select different item by pressing UP or
DOWN and press ENTER to confirm.
P0107
Manifold Absolute
Pressure/Barometric
Pressure Circuit
low
3) After v1ewmg all the codes, you can press EXIT to return to the previous
15