8
USING YOUR ANCHOR AUDIO WIRELESS MICROPHONES
The very first time you connect an Anchor Audio wireless microphone to your Mini, you will
need to pair it. After the first time, your speaker will recognize the microphone automatically
when you turn the microphone on.
Anchor Audio’s wireless microphones have a range of 300’ line-of-sight from the Mini.
Wireless receiver on
equipped Mini back panel
Anchor Audio belt pack and handheld
wireless microphone
TO PAIR WIRELESS MICROPHONES
NOTE: You may pair only one microphone at a time.
Each Mic Receiver included supports two wireless microphones. Two Receivers = Four
wireless microphones supported. You will only need to pair each microphone one time.
1. Start with your speaker turned on, and turn the Wireless Volume (VOL) knob clockwise.
Then, press and hold the PAIRING button until the green light for Mic 1 flashes. Release
the button.
2. Turn the wireless microphone or belt pack on, then press and hold the MUTE until the
red light turns off. Release the MUTE button.
3. Press and hold the MUTE button again until a green light flashes on the microphone or
belt pack.
4. The microphone is paired when the green light is solid on both the microphone and the
speaker.
5. Repeat these steps for Mic 2 on the same speaker. (Mic 1 will stay paired through this
process.)
PAIRING
BUTTON
INDICATOR
LIGHTS
WIRELESS
VOLUME/
POWER KNOB
Pair two microphones Pair a handheld
microphone
Pair a belt pack
microphone
To Next Page
Loading...
Need help?
General
