Ancona WRC630 - Maintenance; Replacing Light Pucks; Cleaning Filters

— 17 —
Maintenance
Replacing the Light Pucks
IMPORTANT:
ALWAYS SWITCH OFF THE ELECTRICITY SUPPLY AT THE MAIN PANEL BEFORE CARRYING OUT ANY OPERATION
ON THE APPLIANCE.
u
Make sure the range hood is unplugged or turn OFF
breaker.
v
Remove lters and easy clean panel, push the
spring, pull out the LED puck and unplug it.
CAUTION: PUCK MAY BE HOT, PLEASE
TAKE OUT THE PUCK WHEN THE PUCK IS
COMPLETELY COOL!
w
Replace with a 10.2 Volt, 2.5 Watt max, LED lights.
Plug in new puck and push back into light panel.
x
Turn ON breaker and range hood to test for
operation.
Cleaning Filters
IMPORTANT: Drain oil from bafes, spacers, lters, oil tunnels, oil containers before oil and residue overow!
• Removeallbafes,spacers,lters,greasetray,andoilcontainersanddiscardoilandresidue.
• Washwithwarmsoapywater.NOTE:Stainlesssteelbafes,spacersandoiltunnelaretoprackdishwashersafe.
• Dry thoroughly before replacing and follow directions for installation in reverse.
• Filters should be cleaned after every 30 hours of use.
• Should lters wear out due to age and prolonged use, replace with a new lter.