Hardware Installation
10 SCX 920 Installation Guide
Installing the SCX 920
Parts Required
To install a single controller you start with the following parts:
• SCX 920 Controller
• AC Power Cable
• Input and Output Wires
• Infinet Cable (twisted pair)
• InfiLink 200s as Hubs, Repeaters, or Cable Switching Boxes
Mounting
Caution
You must encase the SCX 920 in a UL approved cabinet to keep its
Open Class rating.
1. Before you begin, look at the front of the SCX 920 cover.
Figure 1 shows the front of the SCX 920.
2. The front cover of the SCX 920 has two Phillips head quarter turn
fasteners aligned down the center, one above the middle and one at
the bottom. Remove those fasteners, holding the cabinet firm so it
does not fall.
3. Remove the cover and place it to one side.
4. If you want to disable the manual overrides, proceed to the next
section and return here when you are finished. Otherwise, continue
with the next step.
Technical Manuals Online! - http://www.tech-man.com
To Next Page
Loading...
