From time to time we will issue software updates for your Andycine
Monitor. To update the firmware (that’s the software that runs inside
your Andycine Monitor), there is a simple procedure you have to follow.
1. Extract the files .bin from the firmware zip file.
2. Copy these files onto a SD Card.
a. AndyOS recommends you use a freshly formatted compatible SD
Card (FAT32 or NTFS).
b. Ensure that the firmware update file is on the root of the SD card,
and not in a folder or sub folder.
3. Insert the SD Card with A6 Max.bin file.
4. Use a freshly charged battery on your A6 Max or connect to mains
power. It is very important that your monitor does not lose power
during a firmware upgrade.
5. Power up your monitor with a long press of the Power Button.
6. Double tap monitor screen to access menu, Select Setting, Select
firmware to update.
7. Watch the screen, the firmware upgrade will start.
8. While the firmware upgrade is happening, an ‘updating firmware’
screen will appear.
9. The firmware upgrade will take up to a few minutes.
Let it finish updating when finish it should reboot, if not, turn it off and
on again
Done
To Next Page
Loading...