Aneng Q10 - Measure V.F.C; Measure Square Wave

Measure V.F.C
1.
2.
Connect the black test lead to the COM Terminal and
the redlead tothe {ait Terminal;
Turn the rotary to {| ,longpress ‘to enter
V.F.C mode, the screen will show voltage when put
the test leads at the correct circuit.
Measure square wave
1. Connect the black test lead to the COM Terminal and
the redlead tothe %3! Terminal;
. Turn the rotary switch to sis , and the default
output frequency is 50Hz. To change the output
frequency, press the SEL button.
. Touch the probes to the desired test points.
*Do not input voltage at this setting.
14