Aneng Q10 - Page 6

Keep fingers behind the finger guards on the
probes.
When the product has already been connected
to the line being measured, do NOT touch the
input terminal that is not in service.
Disconnect the test leads from the circuit before
changing the mode.
When the voltage to be measured exceeds 36V
DC or 25V AC, the operator shall be careful
enough to avoid electric shock.
Misuse of mode or range can lead to hazards,
be cautious. “ 9” will be shown on the display
when the input is out of range.
Low level of a battery will result in incorrect
readings. Change the batteries when battery
level is low. Do not make measurements when
the battery door is not properly placed.