Animo OptiMe - Page 15

2021/01 Rev. 0.4
OptiMeOptiMe
15 / 38
Display Possible cause Solution
E30
BREWER REACH
BREW
TIME OUT
The brewer has left the home
position but did not reach the brew
position within 5,1 sec.
To much ground coffee dispensed
in the brewer cylinder. This happens
during or on the end of the run-in
time of the grinder discs.
The used coffee puck is not pushed
out completely, so when fresh coffee
is dispensed again the brewer
cylinder is overfilled.
Check if the brewer motor runs.
Check if the brewer unit is blocked.
Check if dispensed ground coffee does
not exceed the brewer cylinder volume
(overfill) and readjust the grinder.
Check is the coffee puck is not to wet
and if it is pushed out completely.
Brewer cylinder must me empty after the
puck has been emitted.
The coffee puck should not stick to the
slide, this causes Error 30 again!
Extra: please also read the instructions
in chapter 3. No error code
related problems.
E31
BREWER LEAVE
BREW
TIME OUT
The brewer did not leave its brewing
position within 1,3 sec.
The brewer can’t open anymore after
a brewing cycle.
Check if the brewer unit is mechanical
blocked. Take the brewer out.
Open the brewer.
Remove all the coffee residue from the
cylinder.
Clean the thorough under the hot water
tap.
Treat the error like described as Error
30