6
2. Remove the pan and basket from the appliance and place on a flat surface.
CAUTION! After use the basket will be hot. Do not press the basket release button to remove the
basket from pan until it is placed on a flat, firm and heat-resistant surface.
Using the appliance:
This appliance is able to cook a variety of dishes. Refer to the ‘Cooking Manual’ for reference and
respective cooling times.
1. Connect the supply cord plug into a mains power outlet socket. The appliance is now in standby
mode.
2. Place the ingredients into the basket.
IMPORTANT! Do not fill beyond the MAX mark in the basket.
Do not fill more than 2.5kg food in the basket.
3. Slide the pan and basket back into the appliance.
CAUTION! Never operate the appliance without the basket placed in the pan. Do not touch the
pan and basket during use or immediately after use, the pan and basket gets very hot. Only hold
by the handle.
4. Touch the power button to light up the control panel.
5. Select a preset function or set the time and temperature manually, then touch the power button to start
cooking.
6. For cooking of some ingredients, it may be required to turn the contents in the basket or add small
quantity oil in the cooking ingredients during the cooking process to ensure even cooking and avoid
charring of ingredients positioned at the top of the basket. When this is needed, you can pull out the pan
and basket. The appliance will stop heating automatically. After turning or adding oil, place the pan and
basket back into the appliance to resume cooking.
WARNING! Do not press the basket release button when turning the ingredients. Otherwise, the
pan could fall onto the floor with the possibility of striking and cause serious injuries and damage
to the floor and/or splashing hot contents from the pan.
NOTE: You may slide out the pan and basket to check at any time during the cooking process. The
appliance will pause when the pan and basket is taken out or powered off. The appliance will continue
the cooking process if the pan and basket is slide in or power on again.
7. You can reset the time and temperature during cooking process according to the actual condition.
8. When you hear the “beep-beep” sound, the set time is elapsed, and the cooking cycle is completed.
The appliance is now in standby mode.
9. Check if the ingredients are cooked to your satisfaction. If not, set the timer for a few more minutes
until it cooked to your satisfaction.
10. Remove the pan and basket from the appliance. Only hold by the handle as other surfaces will be
hot. Press the basket release button to remove the basket and tip contents onto a dish or place the pan
and basket on a flat firm and heat-resistant surface. During the cooking process, oil from food will drip
and be collected on the bottom of the pan. This can be cleaned at the end of the cooking process when
the pan has cooled down.
To Next Page
Loading...
Need help?
General
