anko ART06001A - Advanced Functions and Maintenance; Preset Cooking Function; Cleaning and Maintenance

PRESET COOKING
Your cooker has a preset function to delay the start of cooking for 24hr. The preset
function does not apply to KEEP WARM function. Following shows how to program
for preset cooking.
1. Follow steps in previous “OPERATION” section to set a cooking program.
2. After program selection, press PRESET button to set the preset time.
3. The time set is the delayed time before the cooking program starts. Please allow
sufficient cooking time before serving.
4. Press START button and the preset function will start. The time on LED display
counts down and the PRESET indicator lights up.
5. When PRESET time reaches 0:00, the cooker will enter the selected auto menu
and start cooking.
6. To cancel the PRESET operation, press STOP to turn OFF the cooker.
IMPORTANT!
• It is not recommended to use the preset function for perishable foods, such as
meat and fish, which may go bad when left at room temperature for hours.
• Pay attention when using Preset function with the RICE program. Cooked rice
may yield overly soft texture due to long soaking time.
CLEANING AND MAINTENANCE
The cooker should be cleaned thoroughly after every use.
1. Unplug the appliance and let it cool down before cleaning.
2. Remove the inner pot, basket fryer, steam shield and condensation collector. Wash it in
warm soapy water with a non-abrasive sponge. Rinse and dry thoroughly. Replace them
into the cooker base.
Remove the Condensation Collector
To remove the condensation collector, pull from left or right-hand side. For cleaning, open the lid of the collector
box, and rinse thoroughly under tap water. Install the collector before start cooking.
3. If food residue is stuck on the frying basket or inner pot, fill the pot with water and put in
the frying basket. Allow to soak before cleaning. DO NOT use scouring pads.
4. For the lid and cooker base, wipe them with damp cloth. Dry them thoroughly before
storage.
5. To clean the heat shield, wipe it with a wet cloth or paper towel after it is cooled.
6. Place the accessories inside the cooker base for storage.
7. Always store the Multi Cooker in an upright position.