Figure 6 Adjustment for Unsuficient Tension on Belt
1.First adjust the tension adjusting screw at A, move the main transmitting
shaft forward to increase belt tension. Loosen “A” if reaching its limit. Adjust
the support of B press down to tighten and fix belt and fix belt, then readjust
“A”.
2.If it is still unable to drive, please adjust the gap between front axis of belt and
roller scraper. When gap is too small, belt will be stuck by roller scraper. Turn
the support at D or back the front axis at C to enlarge the gap.
3.If 1 and 2 are in good condition, it may be dough dreg stuck at C, please clean
with air compressor to blow it away.
To Next Page