1 Place base plate (Fig1-15) to the bottom of
stuffing pump and fix it with 4 pcs of wing
nuts.
2 Set and fix the stuffing pump on the
machine. (Pull up 2 handles at the both
sides to fix.)
3 Set the copper bushing horizontally into
stuffing pump. The copper bushing
should be able to turn and slide inside. If
it does not, set it again.
4 Set the axis of stuffing pump evenly on the
copper bushing and be sure its protrusion
is facing down. The axis should be able to
turn and slide inside.
To Next Page