21 Place the forming mold on the pivot.
22 Insert the bottom plate of flour basket, then
pull out the set fixture bolt and push the
forming mold inward and make sure the
forming mold is tightly fix by the fixture bolt.
to set the forming mold.
23 Pull the coupling to couple with forming
mold.
a. Aim the coupling toward the mold
transmitting pin. (Fig. 23-a.)
b. Insert (Fig. 23-b).
24 Remove machine front cover, remove the lid of
water tank, use a water sucker to pump water into
the cooler tank until the water indicator light is off.
(Power on to check).
(About 3000ml water)
To Next Page