anko HLT-700 - Page 44

ANKO-OME-0005(A1)
41
17.
Dough propeller
can not extrude
dough.
a. Dough is too hard.
b. Connect with the wrong
power source.
a. Water should be 38-45% of
flour weight.
b. Reconnect the power source.
18.
The forming mold
vibrates.
a. Fixing pin is not fixed
properly in hole.
b. Excess flour obstructs the
fixing hole.
a. Reinstall the forming mold.
b. Clean the excess flour, then
reinstall the forming mold.