Anritsu MP1800A - Page 205

7.4 Automatic Measurement Commands
7-87
7
Remote Commands
7.4.4.1 Measurement setting commands
Figure 7.4.4.1-1 Measurement Setting Items
Table 7.4.4.1-1 Measurement Setting Commands
No. Item Command
[1] Start :SENSe:MEASure:BATHtub:STARt
[2] Stop :SENSe:MEASure:BATHtub:STOP
[3] Measurement status query :SENSe:MEASure:BATHtub:STATe?
[4] Measurement Mode :SENSe:MEASure:BATHtub:MODE
:SENSe:MEASure:BATHtub:MODE?
[5] Time :SENSe:MEASure:BATHtub:TIME
:SENSe:MEASure:BATHtub:TIME?
[6] Interval :SENSe:MEASure:BATHtub:INTerval
:SENSe:MEASure:BATHtub:INTerval?
[7] Threshold :SENSe:MEASure:BATHtub:DATA
:SENSe:MEASure:BATHtub:DATA?
[8] Phase Resolution :SENSe:MEASure:BATHtub:RESolution:MUI
:SENSe:MEASure:BATHtub:RESolution:MUI?
[9] Fine/Coarse :SENSe:MEASure:BATHtub:ECOunt
:SENSe:MEASure:BATHtub:ECOunt?
[4] to [6]
[8]
[9]
[11]
[13]
[7]
[10]
[2],[3]
[1],[3]
[12]
[14]
[15]
[17]
[18] [19] [16]
[20],[21]