Anritsu MT9083 Series - SRE Service Request Enable Command; SRE? Service Request Enable Query

3.1 Star (IEEE 488.2) Subsystem Commands
3-7
3
Platform SCPI Commands
3.1.9 *SRE Service Request Enable Command
Syntax:
*SRE<wsp><value>
Description:
The standard Service Request Enable command (*SRE) sets bits in the
Service Request Enable register. A 1 in a bit in the enable register enables the
corresponding bit in the Service Request Enable register. The register is cleared at
power-on. The *RST and *CLS commands do not affect the register.
Parameters:
The bit value for the register (a short value):
7 Operation Status Summary 128
6 Master Summary Status (MSS) / Request Service (RQS) 64
5 Standard Event Status Summary (ESB) 32
4 Message Available (MAV) 16
3 Questionable Status Summary 8
2 Error/Event Queue Summary 4
1 Available 2
0 Available 1
Response:
None
Example:
*SRE 64
3.1.10 *SRE? Service Request Enable Query
Syntax:
*SRE?
Description:
The Service Request Enable query *SRE? returns the contents of the Service
Request Enable register (see *SRE for information on this register).
Parameters:
None
Response:
The bit value for the register (a short value).
7 Operation Status Summary 128
6 Master Summary Status (MSS) / Request Service (RQS) 64
5 Standard Event Status Summary (ESB) 32
4 Message Available (MAV) 16
3 Questionable Status Summary 8
2 Error/Event Queue Summary 4
1 Available 2
0 Available 1
Example:
*SRE?
−>
21<END>