Anritsu MT9083 Series - Status Subsystem Commands

3.3 Status Subsystem Commands
3-11
3
Platform SCPI Commands
3.3 Status Subsystem Commands
All commands in this section are prepared for future functions. All the
registers regarding these commands are set to 0 now.
3.3.1 STATus:OPERation[:EVENt]?
Syntax:
STATus:OPERation[:EVENt]?
Description:
Queries the operation event register.
Parameters:
None
Response:
The bit value for the operation event register as a short value (0 .. +32767)
Example:
STAT:OPER?
−>
0<END>
3.3.2 STATus:OPERation:CONDition?
Syntax:
STATus:OPERation:CONDition?
Description:
Queries the operation condition register.
Parameters:
None
Response:
The bit value for the operation condition register as a short value (0 .. +32767)
Example:
STAT:OPER:COND?
−>
16<END>
3.3.3 STATus:OPERation:BIT#:CONDition?
Syntax:
STATus:OPERation:BIT<n>:CONDition?
Description:
This command accesses the user-definable bits in the OPERation register set. The
value of <n> is restricted from 8 to 12 and represents bits 8 through 12 in
the :STATus:OPERation status register.
Parameters:
None
Response:
The bit value for the operation condition register as a short value (0 .. 1)
Example:
STAT:OPER:BIT8:COND?
−>
1<END>
3.3.4 STATus:OPERation:BIT#:ENABle
Syntax:
STATus:OPERation:BIT<n>:ENABle<wsp><value>
Description:
Sets the operation enable mask for the event register specified bit.
The value of <n> is restricted from 8 to 12 and represents bits 8 through 12
Parameters:
The bit value for the operation enable mask as a short value (0 .. 1)
Response:
None
Example:
STAT:OPER:BIT11:ENAB 1