Anritsu MT9083 Series - DISPlay Subsystem Commands

4.6 DISPlay Subsystem Commands
4-31
4
OTDR Commands
4.6 DISPlay Subsystem Commands
The DISPlay subsystem provides access to the display mode and display
zooming/scaling.
4.6.1 DISPlay:MODE Command
Syntax: DISPlay:MODE<wsp><mode>
Parameters: <mode> Display mode
Numeric format
Range: 0|1|2
0 – From A, 1 – From B, 2 – From Origin
Description: Set display mode (From Origin, From A, From B).
Example: disp:mode 2
Response: None
Errors: (–224, "std_illegalValue, Invalid Parameter Value")
4.6.2 DISPlay:MODE? Command
Syntax: DISPlay:MODE?
Parameters: None
Description: Get display mode (From Origin, From A, From B).
Example: disp:mode? --- 1<END>
Response: Display mode as numeric values.
Errors: None
4.6.3 DISPlay:ZOOM:FULL Command
Syntax: DISPlay:ZOOM:FULL
Parameters: None
Description: Set display zoom to full trace in current display mode
Example: disp:zoom:full
Response: None
Errors: None