Anritsu Site Master S331D - Page 4

Upload Sweep Trace – Control Byte #36 (24h) ..............................62
Get Options – Control Byte #37 (25h) ...................................71
Query Power Level – Control Byte #39 (27h) (Option 29 only) ......................72
Set Power Meter Units – Control Byte #40 (28h) (Option 29 only) ....................72
Power Meter Relative Mode On/Off – Control Byte #41 (29h) (Option 29 only) .............73
Power Meter Offset Mode On/Off – Control Byte #42 (2Ah) (Option 29 only) ..............73
Power Meter Zero Mode On/Off – Control Byte #43 (2Bh) (Option 29 only) ...............73
Power Meter RMS Averaging On/Off – Control Byte #44 (2Ch) (Option 29 only) ............73
Power Meter Center Freq and Span Setup – Control Byte #45 (2Dh) (Option 29 only) ..........74
Trigger Sweep – Control Byte #48 (30h) ..................................74
Trigger Sweep – Control Word (AA30h) ..................................74
Check Battery Status – Control Byte #50 (32h) ...............................74
Set SPA Minimum Sweep Time - Control Byte #53 (35h) .........................75
Set Trigger Position - Control Byte #54 (36h) ...............................75
Set Video Trigger Level - Control Byte #55 (37h) .............................75
Automatically Save Runtime Setup – Control Byte #64 (40h) .......................76
Enter Remote Mode – Control Byte #69 (45h) ...............................76
Enter Remote Mode Immediately – Control Byte #70 (46h) ........................76
Write Custom Cable – Control Byte #80 (50h) ...............................77
Recall Custom Cable – Control Byte #81 (51h)...............................77
Write Antenna – Control Byte #82 (52h) ..................................78
Recall Antenna – Control Byte #83 (53h) .................................78
Set Field Strength Measurement – Control Byte #84 (54h) .........................79
Set Channel Power – Control Byte #85 (55h) ................................79
Read Channel Power – Control Byte #86 (56h) ...............................80
Set Adjacent Channel Power Ratio (ACPR) – Control Byte #87 (57h)...................80
Read Adjacent Channel Power Ratio (ACPR) – Control Byte #88 (58h)..................80
Read Signal Standard Name – Control Byte #89 (59h) ...........................81
Measure OCC BW % of Power – Control Byte #96 (60h) .........................81
Measure OCC BW dB Down – Control Byte #97 (61h) ..........................82
Set Bias Tee Function - Control Byte #98 (62h) (Option 10 only) .....................82
Set Spectrum Analyzer Start/Stop Frequency – Control Byte #99 (63h) ..................83
Set Spectrum Analyzer Center Freq./Span – Control Byte #100 (64h) ...................83
Set Spectrum Analyzer Scale – Control Byte #101 (65h) ..........................83
Set Spectrum Analyzer Marker – Control Byte #102 (66h).........................84
Set Spectrum Analyzer Single Limit – Control Byte #103 (67h) ......................84
Set Spectrum Analyzer Peak Hold – Control Byte #105 (69h) .......................85
Set Spectrum Analyzer Resolution Bandwidth – Control Byte #106 (6Ah) ................85
Set Spectrum Analyzer Video Bandwidth – Control Byte #107 (6Bh) ...................85
Set Spectrum Analyzer Sweep Mode – Control Byte #108 (6Ch) .....................86
ii Site Master PM