Anritsu SQA-R MP1900A - SAS-3;-4 Receiver Test

16
Application Examples
Wideband BERTS
The same configuration covers SAS-3 (12 Gbit/s), SAS-4 (22.5 Gbit/s)
and PCI Gen1 to Gen5 measurements.
Required Functions
• 12 Gbit/s to 22.5 Gbit/s BERTS
• Stressed Signal Calibration and Test
• Jitter Margin Test
Receiver Test
Stressed signal calibration and measurements can be automated using
the automation software to shorten the design stage by cutting
Compliance test times and improving measurement reproducibility.
Jitter Margin Test
The automation software supporting jitter tolerance tests helps simplify
receiver performance evaluations required by storage, HBAs, and ICs.
SAS-3/-4 Receiver Test
Test Signal +
Crosstalk Signal
SAS
Receptacle Fixture
ISI
Generator*
Automation Software
Test Report
*
: Should use specified ISI generator by PCIe or SAS
to Error Detector
Tx Signal
Rx Signal
DUT
(Storage Device)
SAS CM source (Optional)