30
Signal Quality Analyzer-R MP1900A Specifications
Refer to the MP1900A Data Sheet (MP1900A_Datasheet-E-A-1) for detailed specifications.
Signal Quality Analyzer-R MP1900A
LCD 12.1” WXGA 1280 × 800
Remote Interface GPIB, LAN
Module Slots 8
External Equipment Interface USB × 6, VGA × 1, HDMI × 1
OS Window Embedded Standard 7
Power Supply
100 V(ac) to 120 V(ac), 200 V(ac) to 240 V(ac), 50 Hz to 60 Hz
Power consumption: 1350 VA max.
Dimensions and Mass 340 (W) × 222.5 (H) × 451 (D) mm, 20 kg (excluding modules)
CE
EMC 2014/30/EU, EN61326-1, EN61000-3-2
LVD 2014/35/EU, EN61010-1
RoHS 2011/65/EU, EN50581
12.5 GHz 4 Port Synthesizer MU181000B
Clock Output
Number of Output: 4
Frequency Range: 0.1 GHz to 12.5 GHz, Steps: 1 kHz/1 MHz
Level: 0.4 Vp-p to 1 Vp-p (AC)
Connector: SMA (f), Termination: 50Ω/GND
10 MHz Input
Frequency: 10 MHz ±10 ppm
Level: 0.5 Vp-p to 2.0 Vp-p
Connector: BNC, Termination: 50Ω/GND
10 MHz Output
Level: 1.0 Vp-p ±30% (AC)
Connector: BNC, Termination: 50Ω/GND
100 MHz Reference Signal Input
(SSC Extension MU181000B-002)
Outputs either 100 MHz with phase deviation x25, x50, or x80 frequency-multiplied clock from Clock Output connector
Supports PCI Express Host Reflclk input
Modulation Frequency: 30 kHz to 33 kHz
Level: 0.15 Vp-p to 1.3 Vp-p (AC)
Connector: BNC
Jitter Modulation Source MU181500B
External Clock Input
Frequency Range: 0.800 000 GHz to 15.000 000 GHz
Amplitude: 0.4 Vp-p to 1.0 Vp-p
Connector: SMA (f), Termination: 50Ω/AC Coupling
Jittered Clock Output
Number of Output: 2
Amplitude: 0.4 Vp-p to 1.0 Vp-p
Connector: SMA (f), Termination: 50Ω/AC Coupling
SJ1
Modulation Frequency: 10 Hz to 250 MHz
Amplitude: 0 to 2000 UI @Modulation Frequency 10 kHz to 100 kHz
0 to 1 UI @Modulation Frequency 10 MHz to 250 MHz (Different depending on the operating bit rate)
Built-in SJ2 Modulation Frequency: 33 kHz, 87 MHz, 100 MHz, 210 MHz
Spread Spectrum Clocking
(SSC)
Modulation Frequency: 28 kHz to 37 kHz
Deviation: 0 to 7000 ppm
Random Jitter (RJ)
Bandwidth: 10 kHz to 1 GHz
Amplitude: 0 to 0.5 UI (Different depending on the operating frequency)
Bounded Uncorrelated Jitter
(BUJ)
PRBS Pattern Length: 2
n
– 1 (n = 7, 9, 11, 15, 23, or 31)
BUJ Rate: 0.1 Gbit/s to 3.2 Gbit/s, 4.9 Gbit/s to 6.25 Gbit/s, 9.8 Gbit/s to 12.5 Gbit/s
Filter Type (LPF 3 dB Bandwidth): 50, 100, 200, 300, 500 MHz, Through
Amplitude: 0 to 0.5 UI (Different depending on the operating frequency)
External Jitter Bandwidth: 10 kHz to 1 GHz
Noise Generator MU195050A
Number of Channels 2
Insertion Loss –3 dB
CMI: Common Mode Noise 0.1 GHz to 6 GHz: Sinusoidal wave
DMI: Differential Mode Noise 2 GHz to 10 GHz: Sinusoidal wave
White Noise 10 MHz to 10 GHz
Crest Factor >5
To Next Page
Loading...
