70
4. Vertical adjustment lever
NOTE:
(manual adjustment)
5. Panel
6. Wheel
FIG. 1
BACK
7. Handle (on both sides)
8. Air lter (inside grille)
9. Top air inlet
10. Drain
11. Air outlet
12. Bottom air inlet
13. Drain outlet for collection tray
FIG. 2
INSTALLATION
BEFORE INSTALLATION
The place where the product is installed must
comply with the following requirements.
• Place the air conditioner on a level, stable
surface, otherwise there is a risk of
material damage, noise and/or vibration.
• The air conditioner must be placed near
an earthed power point and the collector
tank (on the back) should be easily
accessible.
• Leave a free space of a least 50 centimetres
round the air conditioner for it to work
properly.
FIG. 3
• Do not cover the inlet, outlet or signal
receiver on the air conditioner – this can
damage it.
Tools needed
1. Phillips screwdriver, medium.
2. Tape measure or ruler.
3. Knife or scissors.
4. Saw (to shorten window adapter for small
window).
Accessories description
A. Product adapter
B. Outlet hose
C. Window insert adapter
D. Wall outlet adapter A (only for wall
mounting)
E. Wall outlet adapter B (with cap) (only for
wall mounting)
F. Screw
G. Window insert A
H. Window insert B
I. Screw and screw plug (only for wall
mounting)
J. Foam rubber seal A (self-adhesive)
K. Foam rubber seal B (self-adhesive)
L. Foam rubber seal C (non self-adhesive)
M. Safety fastener with the 2 screws
N. Drain hose
O. Remote control with battery (only for
models with remote control)
FIG. 4
NOTE:
Parts marked with * sold separately.
Window mounting kit
Preparation of outlet hose
Press the outlet hose in the window insert
adapter (wall adapter for wall mounting)
and in the product adapter. The elastic plastic
fasteners on the adapters automatically lock
the hoses.
FIG. 5
To Next Page
Loading...
