Anslut 013946 - Air Direction Adjustment

EN
77
Example:
Follow the instructions below to set automatic
stop in 10 hours.
1. Press the button TIMER OFF. The display
on the remote control shows the last set
stop delay and the status in h.
2. Press the TIMER OFF button repeatedly
until 10h is shown on the display on the
remote control.
3. Wait about 3 seconds until the
temperature display is reset. The function
is now enabled.
FIG. 25
AUTOMATIC STARTING AND STOPPING
(setting of TIMER ON and TIMER OFF at the
same time) TIMER OFF – TIMER ON (on —
stop — start)
This function is useful, for example, to switch
o the air conditioner after you have gone to
bed and to start it again before you get up.
Example:
Follow the instructions below to set automatic
stop in 2 hours and automatic start in 10
hours.
1. Press the button TIMER OFF.
2. Press the TIMER OFF button repeatedly
until 2.0h is shown on the display on the
remote control.
3. Press the button TIMER ON.
4. Press the TIMER ON button repeatedly
until 10h is shown on the display on the
remote control.
5. Wait about 3 seconds until the
temperature display is reset.
FIG. 26
FIG. 27
TIMER ON – TIMER OFF
(o — start — stop)
This function is useful, for example, to start the
air conditioner before you get up and to switch
it o after you have left the house.
Example:
Follow the instructions below to set automatic
start in 2 hours and automatic stop in 5 hours.
1. Press the button TIMER ON.
2. Press the TIMER ON button repeatedly
until 2.0h is shown on the display on the
remote control.
3. Press the button TIMER OFF.
4. Press the TIMER OFF button repeatedly
until 5.0h is shown on the display on the
remote control.
5. Wait about 3 seconds until the
temperature display is reset.
FIG. 28
IMPORTANT:
The mode that comes up rst (TIMER ON or
TIMER OFF) takes place rst.
ECONOMY (SLEEP)
The SLEEP function produces a comfortable
temperature and saves energy when you
are sleeping. The function can only be used
in COOL, HEAT and AUTO mode. Further
information is available in the instructions.
NOTE:
If the air conditioner is in SLEEP mode this
is interrupted if the ON/OFF, FAN SPEED, or
MODE button is pressed.
SETTING THE AIR DIRECTION
Manual setting
• The air deector can be set manually.
• Check that the air deector is completely
open when in heating mode.
• Check that the air deector is open when
in use.
NOTE:
• The status light for timer mode can only
be set from the remote control.
• Never overload the air deector and do