Anslut 013946 - Timer and Delay Settings

EN
76
in the outlets. When the dehumidication
function is in use, the drain plugs must be
stored out of the reach of children in order to
avoid the risk of choking.
1. Check that the air conditioner is
connected to the mains. The status light
on the air conditioner goes on. Press the
MODE button until DRY mode is activated.
2. Press the TEMP button to set the required
temperature from 17 to 30°C in steps of
1°C or from 62 to 88°F in steps of 2°F.
3. Press the ON/OFF button to start the air
conditioner.
NOTE:
In DRY mode it is not possible to set the
fan speed. The fan speed is controlled
automatically.
TIMER
Press the TIMER ON button to activate the
setting of start delay. Press the TIMER OFF
button to activate the setting of stop delay.
SETTING THE START DELAY
1. Press the button TIMER ON. The display on
the remote control shows TIMER ON, the
last set start delay, and the status in h.
2. Press the TIMER ON button again to set
the required start delay. Each time you
press the button the setting increases
in steps of 0.5 hours up to 10 hours and
steps of 1 hour from 10 to 24 hours.
3. When the time for TIMER ON is set a
signal is sent to the air conditioner after
0.5 seconds. After another 2 seconds the
h status disappears and the set point
temperature is shown again on the
display.
SETTING THE STOP DELAY
1. Press the button TIMER OFF. The display
on the remote control shows TIMER OFF,
the last set stop delay and the status in h.
2. Press the TIMER OFF button again to set
the required stop delay. Each time you
press the button the setting increases
in steps of 0.5 hours up to 10 hours and
steps of 1 hour from 10 to 24 hours.
3. When the time for TIMER OFF is set a
signal is sent to the air conditioner after
0.5 seconds. After another 2 seconds the
h status disappears and the set point
temperature is shown again on the
display.
IMPORTANT:
Only the following times can be set:
0.5, 1.0, 1.5, 2.0, 2.5, 3.0, 3.5, 4.0, 4.5, 5.0,
5.5, 6.0, 6.5, 7.0, 7.5, 8.0, 8.5, 9.0, 9.5, 10, 11,
12, 13, 14, 15,16,17, 18, 19, 20, 21, 22, 23 and
24 hours.
EXAMPLE OF TIMER SETTING
TIMER ON (automatic start)
The TIMER ON function is useful, for example,
to start the air conditioner automatically
before you get home.
Example:
Follow the instructions below to set automatic
start in 6 hours:
1. Press the button TIMER ON. The display on
the remote control shows the last set start
delay and the status in h.
2. Press the TIMER ON button repeatedly
until 6:0h is shown on the display on the
remote control.
3. Wait about 3 seconds until the
temperature display is reset. The function
is now enabled.
FIG. 24
TIMER OFF (automatic switching o)
The TIMER OFF function is useful, for example,
to switch o the air conditioner automatically
after you have gone to bed.