Anslut 013946 - Remote Control Functions

EN
73
remote control to set the fan speed. It is
not possible to set the temperature.
3. Do not lead the hose through the window.
DRY (dehumidication)
1. Continue pressing the MODE button until
the DRY status light goes on.
2. In this mode it is not possible to adjust
the set point temperature or fan speed.
The fan motor runs at low speed. Keep
doors and windows closed for best
dehumidication function.
3. Do not lead the hose through the window.
SLEEP/ECO
This function can only be enabled from the
remote control. When the SLEEP function is
enabled the set temperature increases by
1°C/2°F (or 1°F) after 30 minutes.
After another 30 minutes the set temperature
increases by another 1°C/2°F (or 1°F). The new
temperature is maintained for 7 hours, after
which the original set temperature is restored.
The SLEEP mode then nishes and the air
conditioner runs with the original settings.
NOTE:
This function cannot be used in FAN or DRY
mode.
Automatic restart
When the power supply is reset after a power
failure the air conditioner restarts with the
previously set function.
START DELAY 3 MINUTES
When the air conditioner has been stopped
it will not start for 3 minutes. This is a safety
function, and is completely normal.
REMOTE CONTROL
• Operating modes: AUTO, COOL, DRY and
FAN
• 24 hour timer.
• Adjustable range for room temperature:
17 to 30°C and 62 to 88°F
NOTE:
• The remote control is intended for
several models and the buttons can
deviate from the actual model. If the air
conditioner does not have a specic
function nothing will happen when the
corresponding button on the remote
control is pressed.
• The descriptions in the operating
instructions apply before the diagrams
for the remote control.
Positioning
The remote control has a range of 8 metres.
Point the remote control at the receiver on the
air conditioner. An audio prompt conrms the
reception. Doors and curtains etc. can block
the signal on the remote control.
FIG. 20
IMPORTANT:
• Do not expose the remote control to
water or any other liquid. Do not expose
the remote control to heat or direct
sunlight.
• Sunlight or strong articial light can
interfere with the receiver. Protect the
receiver from strong light.
• If the remote control aects other
products in the vicinity, move the
products or contact the retailer.
Replacing the batteries
The remote control has two batteries under a
cover on the back.
1. Open the battery cover.
2. Remove the old batteries and insert new