Anslut 025966 - Refrigerant Safety; Electrical Safety; Servicing Guidelines

EN
33
• Keep doors and windows closed for best
energy-saving economy.
• Do not use or store the product in direct
sunlight.
• The air outlet can get hot during
continuous use on warm days. This is
perfectly normal.
• Empty the water tank before moving the
product.
• Check that the water tank is properly
inserted, otherwise the product will not work.
• The product starts in the mode it was in
when it was switched o.
• The product starts when the humidity
level is 3% higher than the set target
humidity level.
• When the product has been switched o it
cannot be started until after a delay of
3 minutes, to protect the compressor.
• Contact the retailer in the event of
problems or questions.
REFRIGERANT
• The product is intended to be used with
refrigerant R290 (propane).
• The refrigerant circuit is sealed. Service
must only be carried out by qualied
personnel.
• The refrigerant must not be released into
the atmosphere.
• R290 (propane) is ammable and heavier
than air. The gas initially accumulates
near the ground, but can be circulated by
fans or similar devices.
• If leakage of propane is suspects,
troubleshooting must be carried out by
qualied personnel.
• Propane is odourless – the absence of
smell does not mean that there is no
leakage.
• If a leak is detected, immediately evacuate
and ventilate the area, and inform the re
department that there is a propane leak.
• Do not allow anyone to enter the area until
qualied personnel have examined the
situation and determined that it is safe.
• Keep the product away from naked ames,
cigarettes and other sources of heat.
• The components of the product are
designed for use with propane and are
spark-free. Only use identical spare parts.
• Piping should be protected from
mechanical damage and should not be
installed in an unventilated area with a
oor surface less than 4 m
2
.
• Follow national regulations concerning gas.
• The product should be stored in a
well-ventilated area of a size that is at
least equivalent to the minimum allowed
room size for use.
ELECTRICAL SAFETY
• If the power cord or plug are damaged
they must be replaced by an authorised
service centre to ensure safe use.
• Check that the mains voltage corresponds
to the rated voltage on the type plate.
• The plug must be plugged into a correctly
installed earthed power point.
• Pull out the plug before cleaning and
when the product is not in use.
• Do not use the product with wet hands.
Do not expose the product to water or any
other liquid. Do not expose the product to
rain or moisture.
• Never leave the product unattended when
switched on. Avoid tilting or tipping over
the product.
• Do not pull out the plug when the product
is switched on.
• Do not pull the power cord to pull out the
plug.
• Do not use extension cords or adapters
together with the product.
SERVICING
Follow all the instructions and safety
instructions below when working on products
the refrigerant R290.
Safety checks should be carried out before
working on systems containing ammable