Anslut 025966 - Troubleshooting Guide; Common Problems and Solutions; Error Codes and Indicators

EN
39
WASTE DISPOSAL
WARNING!
• Never release refrigerant into the
atmosphere.
TROUBLESHOOTING
The troubleshooting guide is used to identify the causes of common problems and how they can be
rectied. Contact the retailer if the problem cannot be rectied with the help of the troubleshooting
guide.
Problem Possible cause Step
The
dehumidier
does not work
No power.
Plug the plug into a power point that is supplied
with power and start the dehumidier.
The status light for full water
tank ashes.
Empty and replace the water tank. Check that
tank is correctly in place.
Ambient temperature lower
than 5°C or higher than
35°C.
The dehumidier switches o automatically if
the ambient temperature is too low or too high.
The
dehumidier
starts, but
does not work
eectively
Blocked air lter. Clean the lter according to the instructions.
Blocked air inlet or outlet. Clear the air inlet/outlet.
The
dehumidier is
not taking in air
Blocked air lter. Clean the air lter.
Noise
The dehumidier is not
placed on a at surface.
Put the dehumidier on a at surface.
Blocked air lter. Clean the air lter.
E2 Fault on the humidity sensor. Replace sensor.
LO
Ambient humidity less than
20%.
The dehumidier switches o automatically.
HI
Ambient humidity higher
than 90%.
CL
Ambient temperature lower
than 5°C.
CH
Ambient temperature higher
than 35°C.
• Recycle the product at the end of its
useful life in accordance with local
regulations.