Anslut 025966 - Cleaning the Air Filter; Storage Instructions

EN
38
2. Press the power switch to switch o the
dehumidier.
3. Pull out the water tank.
4. Empty the tank in a suitable place.
5. Clean the inside and outside of the water
tank.
6. Replace the water tank in the dehumidier.
7. Press the power switch to start the
dehumidier.
8. If the status light for full water tank does
not go o, remove the water tank again
and check that the oat is correctly
positioned.
FIG. 22
Continuous emptying of the water
tank
Connect the supplied hose to the dehumidier
for continuous emptying or for dehumidication
without supervision. The water will self-drain to
a suitable container or drain.
1. Place the dehumidier on a level, stable
surface.
2. Switch o the dehumidier before tting
the hose.
3. Remove the plug from the water outlet
and put it in a safe place.
4. Connect the hose carefully and check that
it is free from obstructions and kinks.
5. Place the free end of the hose in a suitable
container or drain, and check that the
water can ow freely from the unit.
– Do not put the free end of the hose
under water, this can obstruct
drainage.
– The hose should run downwards with
a minimum inclination of 20°.
FIG. 23
CLEANING THE FILTER
Clean the air lter every other week. Over
time, dust accumulates in the lter, which
limits airow and reduces the dehumidier's
eciency. The dehumidier can be damaged if
the lter is blocked.
The lter can be removed to be cleaned:
1. Detach the lter frame and remove the
lter.
2. Gently vacuum o the dust from the
surface of the lter.
3. If the lter is very dirty it can be washed
with water and a mild detergent. Allow it
to dry completely.
4. Replace the lter.
FIG. 24
NOTE:
Never use the dehumidier without the air
lter, this can cause impurities to accumulate
on the evaporator.
STORAGE
If the dehumidier is not going be used for an
extended period (more than a few weeks), it
should be cleaned and thoroughly dried before
being put into storage. Follow the instructions
below:
1. Turn o the dehumidier with the power
switch and unplug it.
2. Empty the water tank.
3. Clean the lter and allow it dry in a
shaded area.
4. Wind up the power cord on the holder.
5. Replace the lter.
6. The dehumidier must be stored in an
upright position.
7. Store the dehumidier in a dry, well-
ventilated area indoors, protected from a
corrosive atmosphere.
IMPORTANT:
The dehumidier's evaporator must be dry
before storage, otherwise there is a risk of
moulding and/or material damage. Pull out
the plug and leave the product for a few days
in an open, dry area to dry.