Anslut 025966 - Power Switch Operation; Mode Selection

EN
36
DIGITAL DISPLAY
• Ambient humidity less than 45%:
Blue light.
• Ambient humidity from 45 to 65%:
Green light.
• Ambient humidity higher than 65%:
Red light.
• The LED display shows E0, E2, CL, CH, LO
or HI: Red light.
• Night reduction mode: O.
USE
POSITIONING
Place the dehumidier on a at stable surface
with at least 30 cm of free space on all sides to
ensure the adequate circulation of air.
FIG. 21
Take the following into consideration:
• Do not install near sources of heat, such
as radiators, cookers or other equipment
that produces heat.
• Do not put it where it can be exposed to
splashing water, oil or other liquids.
• Do not expose it to high temperatures or
direct sunlight.
• Do not subject it to knocks or continuous
vibration.
• Do not expose it to dust.
• Do not put the dehumidier where it will
not receive sucient ventilation (for
example, in a cupboard or on a shelf).
• Do not put it on an uneven surface.
WARNING!
• Do not install in an area with a oor
surface less than 4 m
2
.
• Do not use the dehumidier in the
vicinity of ammable liquids or gas.
FUNCTIONS OF CONTROL PANEL
Power switch
1. When the dehumidier is in standby
mode, press the power switch to start
it. The status light goes on and the
dehumidier starts with default settings
(high fan speed and target air humidity
of 50%).
2. When the dehumidier is running, press
the power switch to switch it o. The
status light goes out, the compressor
turns o immediately, and the fan stops
after 30 seconds.
NOTE:
Place the air deector in an upward position
before starting.
Mode
Each press of the button toggles
between automatic mode – continuous
dehumidication – night mode. The
corresponding status light goes on.
Automatic mode
• When the humidity level is at least 3%
higher than the set target humidity, the
fan starts and the compressor starts 3
seconds later.
• When the humidity level is at least 3%
lower than the set target humidity, the
compressor stops and the fan stops 30
seconds later.
• The fan speed can be adjusted in
automatic mode.
Continuous dehumidifying
The dehumidier runs continuously, and target
humidity cannot be adjusted.
Night reduction
1. Press the button for night reduction.
The status light in the button goes on
and night reduction is activated. If no
buttons are pressed within 10 seconds,
all status lights go out and low fan speed
is set.
2. Press any button to switch on the status
lights.