Antelope Goliath - DAW Integration Issues

29
DAW
● What buffer size is your DAW set to?
● If it is signicantly low i.e. lower than 128 samples in your buffer size, try increasing it.
Try increasing the buffer size from the Goliath control panel (Windows Only)
● Have you checked the input and output routing is correct in your DAW?
● Is the Goliath device selected in the relevant sound card section of the DAW’s preferences?
If the Goliath doesn’t show up in you DAW, rst try unplugging and plugging back the
Thunderbolt
TM
cable (or the USB cable), then restarting your Computer and nally re-install the
rmware, drivers and control panel for the Goliath.