43
Example 1: Select a Source for the ZONE2 Timer:
• Enter the Setup (section 7.1). Go to ‘1. SET TIME/TIMERS’ and press SELECT.
•Press the button until you reach ‘f. SET ZONE2 TIMERS’.
•Press SELECT. The ‘1f. SET ZONE2 TIMERS’ submenu will appear.
•Press the button until you reach ‘e. SELECT SOURCE’.
• Use the buttons to change to desired Source.
•Press BACK to leave this submenu and return to the SET TIME/TIMERS menu.
If you selected ‘Last Stn’ as your Timer turn-on Source, you can leave it set to the last station you were
listening to, or choose one of your preset stations. To have the Timer turn on to a Preset Station, do the
following from the ‘e. SELECT SOURCE’ menu line (above):
• Use the buttons to change to ‘Last Stn’.
•Press SELECT to highlight ‘Last Stn’.
• Use the buttons to change to the desired FM • AM Preset. These will scroll from ‘AM 1-1’ to
‘AM 1-6’ to ‘FM1-1’ through to ‘FM3-6’ and back to ‘Last Stn’.
•Press BACK to leave this submenu.
Note: The Timer submenu setup procedure is the same for MAIN, ZONE2, and ZONE3.
Example 2: Change ZONE2, TIMER2 to come on Weekdays at 7:35 AM.
• Enter the Setup (section 7.1). Go to ‘1. SET TIME/TIMERS’ and press SELECT.
•Press the button until you reach ‘f. SET ZONE2 TIMERS’.
•Press SELECT. The ‘1f. SET ZONE2 TIMERS’ submenu will appear.
•Press the button to reach ‘TIMER 2: Off’.
• Use the buttons to change to ‘Week’.
•Press the button until you reach ‘a. T2 WEEKDAY ON: 8:00 AM’.
•Press SELECT. The hour is now in red, use the Master Control Knob or the buttons to set the
hour to ‘7’ AM. (Continuing through ‘12’ will advance the AM/PM settings.)
•Press the button. ‘00’ minutes will be highlighted.
• Use the Master Control Knob or the buttons to set the minutes to ‘35’.
•Press BACK to leave this submenu and return to SET TIME/TIMERS menu.
Note: When scrolling between ‘11 PM’ and ‘12 AM’ settings, the display shows ‘--:--’. Timers set in the
‘--:--’ position will be skipped. Thus, to set the Timer to only turn on, set the Off time to ‘--:--’. To
set the Timer to only turn off, set the On time to ‘--:--’.
7. SETUP MENU continued …
To Next Page
Loading...
