EasyManua.ls Logo

Anthem MDX-8 - ARC Micro-USB Connection; Chassis Ground; Fuse

Anthem MDX-8
40 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
27
back panel ashes as will the Power indicator on the front of
the MDX. You can also match the MAC Address shown under
General > Information with the unique MAC Address printed
on the back of each MDX.
3.19 ARC MICRO-USB CONNECTION
If a local area network connection is not available the Anthem
Room Correction (ARC) software can still connect to the unit
by making use of this micro-USB connector. Connect a USB
type A to micro B cable between the MDX and your PC or Mac.
3.20 CHASSIS GROUND
The MDX is powered using a double-insulated power cord and
therefore does not have an earth ground connection to avoid
hum. If an earth ground connection is required, or if connect-
ing to another chassis ground, you can connect a wire using
the thumbscrew.
3.21 FUSE
To replace the fuse, rst set the Master Power switch to O
and disconnect the power cord, Using a small slotted screw-
driver, remove the fuse cap and replace the fuse with a match-
ing type and rating as shown at the back of the unit.