4.
Initial setting
Satellite signal acquisition, time setting and automatic
backlighting.
Automatic backlight
This device automatically calculates the sunrise
time
and
sunset time, from the time half an hour before sunset
to
half an hour after sunrise, the backlight is automatically
brightened, the rest of the time the backlight is
turned off if
no operation is detected in 15 seconds.
Acquisition of satellite signals
Please make sure the device is outdoors and
in the open air.
Normally it may take 15 ~ 90 seconds to locate satellite
signals, stay
stationary when satellite signals are received.
This device can use speed sensor or GPS for speed tracking, if
the speed sensor is not connected, the device uses GPS for
speed tracking and uses the speed sensor when the sensor is
connected.
Time setting
The time and date are automatically calibrated after
the
satellite signals are found when the device is turned on
(please set the time zone correctly, refer to the Time Zone
Setting chapter) or connect the device to the app
(CoospoRide) to
synchronize
the time.
To Next Page
Loading...