Antunes VCT-1000 Series - Unit Installation Guide; Unpacking and Initial Setup; Assembling Toaster Components

5
P/N 1010807 Rev. Q 09/18
®
Installation
Unpacking
1. Remove unit and all packing materials
from shipping carton.
2. Open the large box. It should contain:
y Bun Feeder (Figure 1)
y Bun Chute (Figure 2)
y Two Release Sheets (Figure 1)
y Authorized Service Agency Directory
y Owner’s Manual
3. Remove all packing materials and
protective coverings from the unit and
parts.
NOTICE: If any parts are missing or
damaged, contact Antunes Cus-
tomer Service IMMEDIATELY at
+1-877-392-7856 (toll free).
Assembling the Unit
NOTICE: The factory has pre-installed
a Release Sheet over the Platen
(Figure 1). Verify that it is prop-
erly in place before proceeding.
1. Install the Bun Feeder (Figure 1) and
Bun Chute (Figure 2).
NOTICE: As of March 2017, the Inter-
lock Switch was removed from
use. If your toaster has the
Interlock Switch (Figure 11),
you will need to place the Heat
Shield onto the toaster in order
for the conveyors to turn. If your
toaster does not have an Inter-
lock Switch, the conveyors will
turn as long as the unit is on.
NOTICE: Check the Release Sheet to
make sure it is not caught in the
conveyor. Additional Release
Sheets can be purchased
through your Authorized Service
AgencyunderP/N7000249(3-
pack) or 7000250 (10-pack).
CAUTION
Failure to use Release Sheets may
result in damage to the unit and loss of
warranty coverage.
CAUTION
Bread may burn. Therefore toasters
must not be used near or below curtains
or other combustible walls and materi-
als. Failure to maintain safe operating
distances may cause discoloration or
combustion.
Heat
Shield
Conveyor
Cover Assy.
(Rear)
Yellow
Support Rod
(front)
Conveyor
Cover Assy.
(rear)
Release
Sheet
Yellow Support Rod
(rear)
Bun
Feeder
Shown without optional
Roller Tensioners and
Belt Wraps.
Rear Conveyor Belt
Chain
Front Con-
veyor Belt
Chain
Platen
Conveyor Interlock Switch
(Some Models)
Figure 1. Toaster and Accessories
Bun Chute
Yellow
Support
Rod
Hook Bun Chute
over rear bottom
Conveyor Cover
Yellow Support Rod
Heat
Shield
Bun Feeder
Conveyor
Cover Assy.
(Front)
Conveyor
Cover Assy.
(Rear)
Shown without optional
Roller Tensioners and
Belt Wraps.
Figure 2. Installing Bun Chute